PurePro - Plug n' Go

INDIRECT WATER HEATERS


		Sales Sheet/Specs (921KB) Installation Manual (338kb)

	The Plug n' Go by PurePro is the most complete indirect water heater package available. It takes installation to a new level of simplicity with all accessories factory installed and ready to run. The tank uses a seamless plastic liner that will not crack, chip or peel. This polyethylene reservoir is surrounded by high-density urethane insulation and enclosed in a steel outer shell with a durable appliance-like finish. The Plug n' Go by PurePro even includes a pre-installed bottom drain. Now, you're ready for any installation, simply Plug n' Go.

Removable Heat Exchanger

High-performance in a durable package
Brass plate and cold water inlet pipe provide a strong connection and meet stringent safety codes
Threaded black iron pipe for the boiler supply and return withstand rough handling and require no back-up wrench
Low pressure drop - multiple coil passes allow the use of standard circulator. No large, expensive pump necessary.
Proudly Manufactured in the USA

Features:

Includes Taco 007 circulator with built-in priority relay and flow check
Circulator pre-plumbed and wired to control
All connections ready-tosolder 3/4" Type-L copper
Includes 8 ft. of metalshielded 14-gauge conduit with wire nuts and connectors
Maximized Heat-Transfer Technology - 8 times faster than cupronickel, 25 times faster than stainless steel
Maximized height/diameter spacing to create a chimney effect of thermal currents which scrubs more heat into the water faster
High-output capabilities to handle larger demands
T & P valve pre-installed
Available with Limited Lifetime or 5-year Transferable warranty